TEPCO: nuclear plant was 'unprepared'
Source: Agencies |
June 20, 2011, Monday
|
Print Edition
Print Edition
A NEW report says Japan's tsunami-ravaged nuclear plant was so unprepared for the disaster that workers had to bring protective gear and an emergency manual from distant buildings and borrow equipment from a contractor.
The report, released yesterday by plant operator Tokyo Electric Power Co, is based on interviews of workers and plant data.
It portrays chaos amid the desperate and ultimately unsuccessful battle to protect the Fukushima Dai-ichi nuclear plant from meltdown, and shows that workers struggled with unfamiliar equipment and fear of radiation exposure.
The March 11 earthquake and tsunami destroyed the plant's power and crucial cooling systems, causing three reactor cores to melt and several explosions.
The report reveals insufficient preparations at the plant that TEPCO hadn't previously acknowledged.
When the Unit 1 reactor lost cooling functions two hours after the quake, workers tried to pump in fresh water through a fire pump, but it was broken. A fire engine at the plant couldn't reach the unit because the tsunami left a huge tank blocking the driveway.
Workers destroyed a power-operated gate to bring in the engine that arrived at the unit hours later. It was early morning when they finally started pumping water into the reactor - but the core had already melted by then.
They eventually ran out of fresh water and had to switch to sea water, which meant scrapping the reactor.
Other workers were tasked with releasing pressure from Unit 1's containment vessel to avoid an explosion. But first they had to get the manual, which was not in the control room but in a separate office building at the plant. Aftershocks struck as they retrieved it.
Workers also borrowed batteries and cables from a subcontractor on the compound to set up a backup system to gauge water levels and other key readings, the report says.
The report, released yesterday by plant operator Tokyo Electric Power Co, is based on interviews of workers and plant data.
It portrays chaos amid the desperate and ultimately unsuccessful battle to protect the Fukushima Dai-ichi nuclear plant from meltdown, and shows that workers struggled with unfamiliar equipment and fear of radiation exposure.
The March 11 earthquake and tsunami destroyed the plant's power and crucial cooling systems, causing three reactor cores to melt and several explosions.
The report reveals insufficient preparations at the plant that TEPCO hadn't previously acknowledged.
When the Unit 1 reactor lost cooling functions two hours after the quake, workers tried to pump in fresh water through a fire pump, but it was broken. A fire engine at the plant couldn't reach the unit because the tsunami left a huge tank blocking the driveway.
Workers destroyed a power-operated gate to bring in the engine that arrived at the unit hours later. It was early morning when they finally started pumping water into the reactor - but the core had already melted by then.
They eventually ran out of fresh water and had to switch to sea water, which meant scrapping the reactor.
Other workers were tasked with releasing pressure from Unit 1's containment vessel to avoid an explosion. But first they had to get the manual, which was not in the control room but in a separate office building at the plant. Aftershocks struck as they retrieved it.
Workers also borrowed batteries and cables from a subcontractor on the compound to set up a backup system to gauge water levels and other key readings, the report says.
- About Us
- |
- Terms of Use
- |
-
RSS - |
- Privacy Policy
- |
- Contact Us
- |
- Shanghai Call Center: 962288
- |
- Tip-off hotline: 52920043
- 娌狪CP璇侊細娌狪CP澶05050403鍙-1
- |
- 浜掕仈缃戞柊闂讳俊鎭湇鍔¤鍙瘉锛31120180004
- |
- 缃戠粶瑙嗗惉璁稿彲璇侊細0909346
- |
- 骞挎挱鐢佃鑺傜洰鍒朵綔璁稿彲璇侊細娌瓧绗354鍙
- |
- 澧炲肩數淇′笟鍔＄粡钀ヨ鍙瘉锛氭勃B2-20120012
Copyright 漏 1999- Shanghai Daily. All rights reserved.Preferably viewed with Internet Explorer 8 or newer browsers.
